金年会登录入口

松田浩一



一、基本情况

松田浩一(Koichi Matsuda),男,博士,日本东京人,湖南大学电气与信息工程金年会登录入口教授、博士生导师,岳麓学者领军岗。

松田浩一教授长期从事特种电机优化设计与智能控制领域的研究工作,具有很高的学术水平和丰富的工程经验,取得了一批具有前沿性与创新性,富有科学与工程应用价值的研究成果,共发表国际高水平学术论文168篇(SCI论文120余篇),其中以第一/通讯作者发表SCI论文80余篇,包括IEEE Transactions业内顶级期刊文章70余篇。


E-mail:kpmatsuda@hnu.edu.cn


二、学习与工作经历

2022.09至今 湖南大学电气与信息工程金年会登录入口教授

2021.08-2022.08 华为技术有限公司首席工程师

2017.07-2021.07 日本美蓓亚三美有限公司经理兼首席工程师

2016.04-2017.06 日本博世公司高级工程师

2012.05-2016.03 Magnifye Cambridge Ltd, 电气设计工程师

1996.04-2012.04 日本九洲大学智能机械与系统系助理教授

1993.04-1996.03 日本东京都立科学技术大学航空航天工程博士

1991.04-1993.03 日本东京都立科学技术大学航空航天工程硕士

1987.04-1991.03 日本东京都立科学技术大学航空航天工程学士


三、主要研究方向

1)超导磁悬浮高速电机

2)精密工作台的控制

3)特种电机优化与设计

4)半导体洁净室机器人晶圆转移关键技术研究

5)工厂自动化生产


四、代表性著作与论文

1. L. Fu, K. Matsuda, B. Shen, and T. Coombs, “HTS Flux Pump Charging an HTS Coil: Experiment and Modeling,” IEEE Transactions on Applied Superconductivity, 31(8), 9500805, 2021.

2. L. Fu, K. Matsuda, B. Shen, and T. Coombs, “Charging an HTS Coil: Flux Pump with an HTS Square Bridge,” IEEE Transactions on Applied Superconductivity, 31(8), 3800405, 2021.

3. G. Borelli, J. J. Bonnet, Y. R. Hernandez, K. Matsuda, and J. Damerau, “Spectral-Distance-Based Detection of EMG Activity from Capacitive Measurements,” IEEE Sensors Journal, 18(20), pp. 8502-8509, 2018.

4. L. Fu, K. Matsuda, and T. Coombs, “Linear Flux Pump Device Applied to HTS Magnets: Further Characteristics on Wave Profile, Number of Poles, and Control of Saturated Current,” IEEE Transactions on Applied Superconductivity, 26(3), 0500304, 2016.

5. M. Baghdadi, K. Matsuda, W. Wang, Y. Zhai, and Tim Coombs, “Generation and Confinement of Uniform Magnetic Field Using Second-Generation Superconducting Racetrack Coils,” IEEE Transactions on Applied Superconductivity, 2016, 26(4), 0605004, 2016.

6. L. Fu, K. Matsuda, T. Lecrevisse, Y. Iwase, and T. Coombs, “A Flux Pumping Method Applied to the Magnetization of YBCO Superconducting Coils: Frequency, Amplitude and Waveform Characteristics,” Superconductor Science and Technology, 29(4), 04LT01, 2016.

7. J. Geng, K. Matsuda, L. Fu, Boyang Shen, X. Zhang, and T. Coombs, “Operational Research on a High-Tc Rectifier-Type Superconducting Flux Pump, “Superconductor Science and Technology, 29(3), 035015, 2016.

8. J. Geng, K. Matsuda, L. Fu, J.F. Fagnard, H. Zhang, X. Zhang, B. Shen, Q. Dong, M. Baghdadi, and T. Coombs, “Origin of DC Voltage in Type II Superconducting Flux Pumps: Field, Field Rate of Change, and Current Density Dependence of Resistivity,” Journal of Physics D: Applied Physics, 49(11LT01), 2016.

9. Z. Min, K. Matsuda, and T. Coombs, “New application of Temperature-Dependent Modelling of High Temperature Superconductors: Quench Propagation and Pulse Magnetization, “Journal of Applied Physics, 112(043912), 2012.

10. K. Matsuda and S. Kijimoto, “Reaction Disturbance Cancellation for a Magnetically Levitated Ladder Arm of Clean-Room Robot,” Proceedings of IECON 36th Annual Conference on IEEE Industrial Electronics Society, pp. 1596-1602, 2000.

11. K. Matsuda, Y. Kanemitsu, and S. Kijimoto, “Optimal Number of Stator Poles for Compact Active Radial Magnetic Bearings,” IEEE Transactions on Magnetics, 43(8), pp. 3420-3427, 2007

12. T. Sofue, Y. Kanemitsu, S. Kijimoto, K. Matsuda, and Y. Koba, “Development of Magnetically Levitated Non-Contact Robot: Levitation and Control in Angular and Linear Directions,” Journal of the Japan Society of Applied Electromagnetics and Mechanics, 15(2), pp. 183-188, 2007

13. K. Matsuda, Y. Kanemitsu, and S. Kijimoto, “Stability-Optimized Clearance Configuration of Fluid-Film Bearings,” Transactions of the ASME Journal of Tribology, 129(1), pp. 106-111, 2007.

14. K. Matsuda, Y. Kanemitsu, and S. Kijimoto, “New Method of Vibration Isolation of Scanning Electron Microscope,” Proceedings of SPIE, Device and Process Technologies for MEMS, Microelectronics, and Photonics III, 5276, pp. 473-481, 2004.

15. K. Matsuda, Y. Kanemitsu, S. Kijimoto, and R. Tanaka, “Image-Processing Approach to Vibration Isolation of a Scanning Electron Microscope, “SPIE Journal of Micro/Nanolithography, MEMS, and MOEMS, 3(1), pp. 186-193, 2004.

16. K. Matsuda, S. Kijimoto, and Y. Kanemitsu, “Optimal Clearance Configuration of Fluid-Film Journal Bearings for Stability Improvement, “Transactions of the ASME Journal of Tribology, 126, pp. 125-131, 2004.

17. K. Matsuda, Y. Kanemitsu, S. Kijimoto, S. Itoh, and R. Tanaka, “Control of Image-Shifting Coils for Vibration Isolation of an Electron Microscope,” Proceedings of SPIE, MOEMS and Miniaturized Systems II, 4561, pp. 247-254, 2001.

18. K. Matsuda, N. Kawamura, Y. Kanemitsu, S. Kijimoto, K. Watanabe, and E. Izumi, “Active Vibration Suppression on an Image of a Scanning Electron Microscope,” Proceeding of SPIE, Metrology, Inspection, and Process Control for Microlithography XIV, 3998, pp. 622-630, 2000.

19. K. Matsuda, Y. Kanemitsu, and S. Kijimoto, “A Wave-Based Controller Design for General Flexible Structures,” Journal of Sound and Vibration, 216(2), pp. 269-279, 1998.

20. K. Matsuda, H. Fujii, and T. Ohtsuka,” H? Optimized Wave-Absorbing Control: Analytical and Experimental Results”, AIAA Journal of Guidance, Control, and Dynamics, 16(6), pp. 1146-1153, 1993.


金年会登录入口 - 百度买球指南